REVEX 3PH – Power controller

REVEX 3PH is a fully configurable three phases power controller. If you don’t need features, delete them, so you’ll get an immediate cut on the cost of the unit.

  • Load type: Normal Resistance, Infrared Short, Medium and Long Waveform
  • Inputs: 4:20mA, 0:10V, SSR and ModBus as std.
  • Firing mode: Burst Firing, Zero Crossing
  • Control Mode: Voltage, Current and Power or V2 and I2 with additional Transfer to VxI
  • Communication RS485 with Modbus® protocol std.
  • Two Analog input
  • Two Digital input
  • USB: Port integrated for configuration in safety mode (No Load and Auxiliary Voltage needed) Unit Powered Through USB
  • With the units already programmed you can simply switch On and Go
  • Approvals: Comply with CE+EMC / EAC
  • Dual Current Limit: For peak and RMS value


  • All options are shown below with the relevant model code
  • HB Alarm to diagnose partial or Total Load Failure and Thyristor Short Circuit

cd automation revex 3ph diagram

cd automation revex control board2